![]() ![]() Particular failure that can occur when the driver tries to set up the ![]() System after plugging in the tablet? I'm wondering if it is still loggingĪn "Unknown device_type" message. PTH-660, which is why you see it working on your other system.Ĭould you please provide the last few lines of dmesg from the broken "master" branch (as well as 0.39.0.1.g6cba8da) is compatible with the It might just be an artifact of how you built the driver. "wacom" version should have an actual commit ID rather than "master") but The reported version number is still not quite what I'd expect (the You'll either need to compile the driverįor each different kernel or update your systems to use the exact same On Sat, at 5:47 AM, Jason Gerecke wrote:Įven tiny differences in the kernel version can prevent the driver from usb 1-4: New USB device strings: Mfr=1, Product=2, Kernel.perf_event_max_sample_rate to 79000 perf: interrupt took too long (2508 > 2500), lowering usb 1-11: USB disconnect, device number 7 traps: polkitd general protection ip:7f28cac037f2 nvidia-uvm: Loaded the UVM driver in 8 mode, major device CIFS VFS: cifs_mount failed w/return code = -13 Status code returned 0xc000006d NT_STATUS_LOGON_FAILURE Here is "dmesg" command output, and I just noticed in that machine, itĬan't recognize any model of wacom tablet even the old one like PTH-650Īfter I compile the driver in the machine. Reply to this email directly, view it on GitHub You are receiving this because you authored the thread. $ sudo dracut -f /boot/initramfs-$(uname -r)Īfter a reboot, the system should start using the updated driver. $ sudo tar -xvzPf wacom_$(uname -r).tar.gz With the tarball in hand, you can use the following commands to extractĪnd install it onto other machines running the same architecture/kernel (be $ tar -czPf wacom_$(uname -r).tar.gz /lib/modules/$(uname -r)/extra/*wacom* /etc/depmod.d/nf Should make sure the driver is working properly before creating the archive You could potentially try running the following to generateĪn archive of all the necessary files. Possible to compile the driver on a single machine and install the result Machines share the same architecture (e.g. That you have a tablet connected to the system when running the command.Īs for installing the driver on multiple machines, as long as all the ![]() Or directory" warning indicates that the module isn't loaded. On Sat, at 12:04 AM, Jason Gerecke wrote:įirst, just a quick note about the grep command output. sd 9:0:0:0: Attached SCSI removable diskīut in the log, it keep saying this error: sd 9:0:0:0: Assuming drive cache: write through sd 9:0:0:0: Asking for cache data failed sd 9:0:0:0: Attached scsi generic sg1 type 0 scsi 9:0:0:0: Direct-Access Wacom Intuos Pro M 1.37 PQ: 0 ANSI: 2 usb-storage 1-4:1.3: USB Mass Storage device detected usb 1-4: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-4: New USB device found, idVendor=056a, idProduct=0357 usb 1-4: new full-speed USB device number 8 using xhci_hcd ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |